Engineering Expert Q&A
Find detailed step-by-step explanations for your Engineering questions.
Ask away - we've got answers
TM
Tabitha Mooney
May 20, 2024
The condition of a surface square with the datum plane is called ____.
A) parallelism
B) perpendicularity
C) angularity
D) flatness
A) parallelism
B) perpendicularity
C) angularity
D) flatness
Has Verified Answer
JR
Jacob Rucker
May 20, 2024
The tolerance zone established by the profile-of-a-line tolerance is ____ dimensional, extending along the length of the considered feature.
A) one
B) two
C) three
D) multi-
A) one
B) two
C) three
D) multi-
Has Verified Answer
CM
Chelsy Martin
May 19, 2024
The overall envelope of perfect form within which the feature would just fit is referred to as ____.
A) virtual condition
B) maximum material condition
C) virtual form
D) virtual size
A) virtual condition
B) maximum material condition
C) virtual form
D) virtual size
Has Verified Answer
CG
Charles Griffey
May 19, 2024
When the MMC or LMC modifying symbol is not shown in the feature control frame, it is understood that RFS applies.
Has Verified Answer
AT
Abylay Tastanbekov
May 19, 2024
The balancing point on a lever is called the ____________________.
Has Verified Answer
MT
Mathew Temisan
May 19, 2024
For flat surfaces, ____ target points or areas are required for a primary datum.
A) one
B) two
C) three
D) four
A) one
B) two
C) three
D) four
Has Verified Answer
JE
Jocelyn Espericueta
May 18, 2024
Angularity is a condition of a surface or axis at a specified angle, other than 0° and ____________________°, from a datum or axis.
Has Verified Answer
FK
Fatma Khalid
May 18, 2024
When the length of a datum target line must be controlled, its length and location are dimensioned.
Has Verified Answer
stands for ____________________.HS
Haley Schmidt
May 17, 2024
The use of a die against a piece of flat metal to change its shape is called ____.
A) forging
B) welding
C) stamping
D) pressing
A) forging
B) welding
C) stamping
D) pressing
Has Verified Answer
BC
bryan chavez
May 17, 2024
The origin point is the position from which all coordinate dimensions are taken.
Has Verified Answer
BC
baijun cheng
May 17, 2024
In structural steel shapes, L stands for both equal and unequal leg angles.
Has Verified Answer
LA
Leslie Alaniz
May 17, 2024
The symbol 
on an edge view of a surface tells you that the line is a _________________________.
on an edge view of a surface tells you that the line is a _________________________.Has Verified Answer
JB
Jackson Brown
May 17, 2024
The ratio of gears is a relationship between the revolutions per minute of the gear and _____.
A) diametral pitch
B) pitch diameter
C) outside diameter
D) root diameter
A) diametral pitch
B) pitch diameter
C) outside diameter
D) root diameter
Has Verified Answer
NV
Nathan Vandervoort
May 17, 2024
The pipe schedule number indicates its ____.
A) weight per lineal foot
B) outside diameter
C) inside diameter
D) wall thickness
A) weight per lineal foot
B) outside diameter
C) inside diameter
D) wall thickness
Has Verified Answer